Classic Trucks Homepage Classic Trucks

Currie Rivets

To remove the spring perches, first the heads of the rivets are ground flush. Each rivet is then center-punched and drilled out with a 5/16-inch drill bit. We're going to be using the holes to locate the new perches, so care is taken not to drill the existing holes larger or off center.
Ford F-1 Rearend - Pulling Up The Rear

 To remove the spring perches, first the heads of the rivets are ground flush. Each rivet is then center-punched and drilled out with a 5/16-inch drill bit. We're going to be using the holes to locate the new perches, so care is taken not to drill the existing holes larger or off center.  View Related Article

 

Get Adobe Flash player

Car Research Guide