Classic Trucks Homepage

Pony Seats Plates

For the holes that went through a single layer of sheetmetal, I made these 1/8-inch doubler plates that get welded in from the bottom side. Again, I was hoping to do this without welding on the truck, but doubling up these areas makes good sense. I would imagine that these would help even if you didn't weld them in; use your best judgment.
Pony Seats - The Bump Side Build-Off

 For the holes that went through a single layer of sheetmetal, I made these 1/8-inch doubler plates that get welded in from the bottom side. Again, I was hoping to do this without welding on the truck, but doubling up these areas makes good sense. I would imagine that these would help even if you didn't weld them in; use your best judgment.  View Related Article

 

Car Research Guide