Ralph Davis had restored a clean little Model A Ford that he and his wife Margaret enjoyed cruising around town in and had planned on leaving to their son when they passed on, but they also had a daughter that they didn't want to leave out of the loop. Ralph had received a '50 Ford F-1 as part payment for helping a friend restore his Model A and thought it would be perfect for his daughter Linda. Well, Ralph was knee-deep in the restoration of the F-1 when he passed away in 1998. Linda still inherited the truck, but it was nowhere near the state her dad had in mind for the early gift; now what? Linda's husband, Richard, found himself inheriting the job of finishing where his late father-in-law left off.

This was easier said than done, since during the last few years of his life, Ralph wasn't getting around so well. He did manage, however, to get the F-1 torn down to a shell. In Ralph's time away from the truck, those around it had neglected the project. When Linda and Richard came to claim her inheritance, they found many parts scattered and presumably missing, which made for a rocky start to this large-scale jigsaw puzzle. Ralph was a man on a mission and had set out to restore the Ford to its original glory, so that's the torch the Parks now had to bare for the duration of the next three labor intensive years while the lineage of the '50 was investigated and put to use along the way.

When one commits to a stock restoration they are in for more painstaking work than most custom builds encounter since all the parts and pieces need to be correct or "numbers matching", you can't just to the parts store or flip open any catalog to find what you need, you gotta dig, which was soon found out by Richard, as the first order of business was rebuilding the flatmotor. The 239ci flathead in the truck ran, but was quite tired and it had many passenger car parts on it which wouldn't be right for the resto. As with many of Ford's little water-boilers, when the engine was torn down, too many cracks made themselves known to deem useable. Well, three motors later there were enough satisfactory piece to put an engine together that Ralph would've approved of, so Keith Maness at the Car Quest in Silver City, North Carolina, machined all the iron and Richard put everything back together.

The other major part of the job was fixing the well-worked Southern hauler's sheetmetal. At the time, Richard couldn't find many repro steel parts for the '50, so much of the original tin was fixed the old-fashioned way with patch panels and some hammer and dolly work. The old bed had seen more than its fair share of use, so the obliterated panels were replaced with new ones from Dennis Carpenter Reproductions. Figuring out what the truck's original color was seemed like getting to the center of a Gobstopper. At the bottom of five or six layers of paint, Richard found Ford's Meadow Green hibernating. Memory Lane Auto Restoration in Mocksville, North Carolina, took on the rest of the body and paintwork. Alan Kinder and Tom Baker also suggested the use of a tintable truck bed liner for the underside of the body and fenders to coincide with the other objective the Parks' had, making all this effort and work last as long as possible. On that note, much of the chassis hardware was replaced with stock-spec stainless steel fasteners when possible.

The rest of the truck is a fairly straight-ahead restoration, but with a few period options installed. Not wanting just another old truck, Richard and Linda found a few rare options that were available at the time of the truck's manufacture, but were not a part of their F-1's birth. One of these was an N.O.S. Ford fresh air heater that did just that, pulled fresh air in from outside to use instead of recycling the air inside the cab. They also incorporated a single taillight since only a light on the driver side was standard; the same goes for the addition of the N.O.S. passenger windshield wiper assembly and the Dennis Carpenter stock rear bumper.

Richard rebuilt the remainder of the '50 with a little help from Linda, Billy Davis, and Rich Najera. After going over everything with a fine-toothed comb, Richard called upon the Rumbley Brothers Auto Upholstery in Asheboro, North Carolina, to cover the stock bench with the factory-type brown vinyl that would serve as the perch to grab hold of the stock steering wheel that Richard spent many hours fixing.

Everyone is sure that Ralph would be proud to know that his little old truck went on to win the Stock Best of Show at the 2005 F-100 SuperNationals, as well as some First Place trophies back home.

Facts & Figures
Linda & Richard Park
Franklinville, NC
1950 Ford F-1

CHASSIS FRAME: stock
REAREND: stock / 3.73:1
REAR SUSPENSION: stock parallel leaf
REAR BRAKES: stock 11" drum
FRONT SUSPENSION: stock I-beam
FRONT BRAKES: stock 11" drum
STEERING BOX: stock side steer
WHEELS: Newstalgia Gennie Bare 16x4.5 K
TIRES: 6.00-16 bias-ply Firestone 3 1/4" whitewall
GAS TANK: stock in-cab
DRIVETRAIN ENGINE: 239 ci Flathead V-8
HEADS: stock, Ford of Canada
MANIFOLD / INDUCTION: stock 8BA/RT / 7RT 2-bbl
IGNITION: stock 6-volt
EXHAUST / MUFFLERS: stock / stock
TRANSMISSION: stock three-speed
BODY STYLE: F-1
FENDERS: stock steel
HOOD: stock
GRILLE: stock
BED: steel Dennis Carpenter
BED WOOD: oak
BODYWORK AND PAINT BY: Alan Kinder & Tom Baker Memory Lane Auto Restoration
PAINT TYPE / COLOR: Diamont / stock Ford Meadow Green
HEADLIGHTS / TAILLIGHTS: stock / stock single right taillight
BUMPERS: stock Dennis Carpenter
INTERIOR DASHBOARD: stock
GAUGES: stock
STEERING WHEEL: stock
STEERING COLUMN: stock
SEATS: stock bench
UPHOLSTERY: Rumbley Bros. Auto Upholstery
MATERIAL / COLOR: vinyl / brown
CARPET: black rubber mat
  • «
  • |
  • 1
  • |
  • 2
  • |
  • 3
  • |
  • View Full Article